Power Up Operations
After pressing the key the Power Up Operation menu is shown as in the
following Fig. 16.1.-2.
A051437 2
Fig. 16.1.-2 Menu for Power Up Operations for HMI V5
If the older version of the HMI V4 is used, the menu of the Power Up
Operations is slightly different in accordance to the menu in the former
release 2.0. The menu is as shown in the following Fig. 16.1.-3.
A060410
Fig. 16.1.-3 Menu for Power Up Operations for HMI V4
Select HMI <-> Base Unit address scanning menu item and press ENTER.
The HMI will start polling all the addresses to find the connected Base Units. When
a unit is found, its address and the feeder name are reported.
62
REF 542plusREF 542plus
Multifunction Protection and Switchgear Control Unit
Operator's manual
1MRS755869
To Next Page
Loading...
