ABB Relion 670 series - Page 11

Activating test mode..................................................................150
Connecting test equipment to the IED.......................................150
Verifying analog primary and secondary measurement............151
Releasing the function to be tested...........................................152
Disturbance report.....................................................................152
Introduction...........................................................................152
Disturbance report settings..................................................153
Disturbance recorder (DR)...................................................153
Event recorder (ER) and Event list (EL)...............................154
Identifying the function to test in the technical reference
manual ......................................................................................154
Exit test mode............................................................................155
Basic IED functions........................................................................155
Parameter setting group handling SETGRPS...........................155
Verifying the settings............................................................155
Completing the test..............................................................155
Differential protection......................................................................156
Generator differential protection GENPDIF ..............................156
Verifying the settings............................................................156
Completing the test..............................................................156
Transformer differential protection T2WPDIF and
T3WPDIF ..................................................................................157
Verifying the settings............................................................157
Completing the test..............................................................158
Restricted earth fault protection, low impedance REFPDIF .....158
Verifying the settings............................................................158
Completing the test..............................................................158
High impedance differential protection HZPDIF .......................159
Verifying the settings............................................................159
Completing the test..............................................................160
Impedance protection.....................................................................160
Full scheme distance protection, mho characteristic
ZMHPDIS..................................................................................160
Phase-to-phase faults..........................................................161
Phase-to-earth faults............................................................161
Pole slip protection PSPPPAM..................................................162
Verifying the settings............................................................163
Completing the test..............................................................165
Loss of excitation LEXPDIS ......................................................165
Verifying the settings............................................................165
Completing the test..............................................................167
Current protection...........................................................................167
Instantaneous phase overcurrent protection PHPIOC .............167
Measuring the operate limit of set values.............................168
Table of contents
5
Installation and commissioning manual