ABB Relion 670 series - Making the Electrical Connection to REG670; IED Connectors; Overview

IEC11000039-1-en.vsd
IEC11000039 V1 EN
Figure 21: REX062 measures and drilling plan
REX062 shall be mounted close to the IED. It is recommended that REX060 and
REX062 are mounted in the same cubicle as the IED.
5.4 Making the electrical connection to REG670
5.4.1 IED connectors
5.4.1.1 Overview
The quantity and designation of connectors depend upon the type and size of the
IED. The rear cover plates are prepared with space for the maximum of HW
options for each case size and the cut-outs that are not in use are covered with a
plate from factory.
Section 5 1MRK 502 029-UEN A
Installing the IED
44
Installation and commissioning manual