1 Introduction
1.1 This manual
The communication protocol manual describes a communication protocol
supported by the protection relay. The manual concentrates on vendor-specific
implementations.
1.2 Intended audience
This manual addresses the communication system engineer or system integrator
responsible for pre-engineering and engineering the communication setup in a
substation from a protection relay's perspective.
The system engineer or system integrator must have a basic knowledge of
communication in protection and control systems and thorough knowledge of the
specific communication protocol.
Introduction
2NGA001859 A
10 REX615
IEC 60870-5-104 Communication Protocol Manual
To Next Page
Loading...
