Need help?Do you have a question about the ABB REX615 and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Binary Outputs | Up to 8 |
| Housing | Plastic |
| Weight | Approx. 1.5 kg |
| Type | Relay |
| Voltage Range | 24-250 V DC |
| Communication Protocols | IEC 61850, Modbus, DNP3 |
| Protection Functions | Overcurrent, earth fault |
| Operating Temperature | -40 to +70 °C |
| Mounting | DIN rail |
| Enclosure | IP54 |
Details the manual's scope, purpose, and the intended personnel for installation.
Describes the product documentation set and its intended use during the product life cycle.
Provides details on document revision history and lists other relevant manuals and guides.
Explains the warning, caution, and information symbols used in the document.
Defines conventions for abbreviations, terms, parameter names, and data representation.
Discusses the product's design for sustainability, including manufacturing and lifetime.
Provides guidelines for the proper disposal of the protection relay and its components.
Instructions for unpacking, identifying the product, and checking for damage during transport.
Procedures to verify all delivery items are present and to inspect products for any damage.
Guidance on reporting transit damage and proper storage conditions for the product.
Ensures the installation site meets environmental and spatial requirements for the REX615 relay.
Lists the specific tools necessary for the mounting and installation process.
Step-by-step guide to remove the old SPACOM relay and prepare wiring for the new REX615.
Instructions on how to modify the panel cutout to fit the REX615 relay.
Detailed steps for flush mounting the REX615 protection relay into a panel cutout.
Specifies the necessary tools for making electrical connections to the relay.
Instructions for establishing the protective earth connection for the REX615 relay.
Steps to complete the wiring connections and connect pre-wired terminals to the REX615.
Guidance on how to safely energize the REX615 protection relay after installation.
To Next Page
