8. Loosen the fixing screws of the SPACOM relay, detach the fixing parts and take
the existing SPACOM relay out of the panel cutout.
Figure 12: Loosen the fixing screws of SPACOM relay and detach fixing parts
Figure 13: Taking out the SPACOM relay from the existing location
4.4 Preparing a cutout for REX615
Increase the existing SPACOM relay panel cutout for new REX615 relay by using the
cutting tool and dedicated cutting head for SPACOM 100 series relays.
4TLB000504 A
Mounting
Installation Manual
25
To Next Page
Loading...
