6. Remove the wires also from the existing orange color connector, if included,
and connect the wires on the corresponding terminal of retrofit connector by
following the terminal numbering.
Figure 10: a) Removing wires also from existing orange color connector, if
included, and b) connecting the wires on the corresponding terminal of retrofit
connector by following the terminal numbering
7. After the re-wiring is completed, loosen the fixing screw, remove the installation
support frame, if used, and put it aside.
Figure 11: Loosening the fixing screws of SPACOM relay and detaching the
installation support frame
Mounting
4TLB000504 A
24
Installation Manual
To Next Page
Loading...
