4. Support the earth lead so that it cannot break or weaken.
Be aware of the mechanical, chemical, and electrochemical environment.
5.3 Finalization of the wirings and connecting the pre-
wired terminals to REX615
All connections are made on the rear of the case. No soldering is needed.
Open the screw-compression type terminals before inserting any wires. The CT/VT
terminals are closed at the time of delivery.
Check the terminal diagram of REX615 from the Installation and Technical
Manuals of REX615.
See the specific card variants from the Application manual of REX615.
1. Remove wires from the separate push-in type terminals of the installation
support frame REX615 CT/VT connectors and re-connect them to REX615 by
following the numbering.
Figure 23: Removing wires from temporary push-in terminal to the CT/VT
connector X120 of REX615 by following the numbering
Connecting
4TLB000504 A
32
Installation Manual
To Next Page
Loading...
