1.4.2 Document conventions
A particular convention may not be used in this manual.
• Abbreviations and acronyms are spelled out in the glossary. The glossary also
contains definitions of important terms.
• Push button navigation in the LHMI menu structure is presented by using the
push button icons.
To navigate between the options, use
and .
• Menu paths are presented in bold.
Select Main menu/Settings.
• LHMI messages are shown in Courier font.
To save the changes in nonvolatile memory, select Yes and press .
• Parameter names are shown in italics.
The function can be enabled and disabled with the Operation setting.
• Parameter values are indicated with quotation marks.
The corresponding parameter values are "On" and "Off".
• Input/output messages and monitored data names are shown in Courier font.
When the function starts, the START output is set to TRUE.
• This document assumes that the parameter setting visibility is "Advanced".
1.4.3 Functions, codes and symbols
Table 1: Functions included in the relay
Function
IEC 61850 IEC 60617 IEC-ANSI
Protection
Residual overvoltage protection,
instance 1
ROVPTOV1 Uo> (1) 59G (1)
Residual overvoltage protection,
instance 2
ROVPTOV2 Uo> (2) 59G (2)
Residual overvoltage protection,
instance 3
ROVPTOV3 Uo> (3) 59G (3)
Three-phase undervoltage protection,
instance 1
PHPTUV1 3U< (1) 27(1)
Three-phase undervoltage protection,
instance 2
PHPTUV2 3U< (2) 27(2)
Three-phase undervoltage protection,
instance 3
PHPTUV3 3U< (3) 27(3)
Three-phase overvoltage protection,
instance 1
PHPTOV1 3U> (1) 59(1)
Three-phase overvoltage protection,
instance 2
PHPTOV2 3U> (2) 59(2)
Three-phase overvoltage protection,
instance 3
PHPTOV3 3U> (3) 59(3)
Positive-sequence undervoltage
protection, instance 1
PSPTUV1 U1< (1) 47U+(1)
Table continues on next page
Section 1 1MRS758335 B
Introduction
6 REU611
Application Manual
To Next Page
Loading...
