Section 3 REU611 standardized configuration
3.1 Standardized configuration
REU611 is available in one configuration.
To increase the user-friendliness of the configuration and to emphasize the simplicity
of usage of the relay, only the application-specific parameters need setting within the
relay's intended area of application.
The standard signal configuration can be altered by local HMI, Web HMI or optional
application functionality of Protection and Control IED Manager PCM600.
Table 9: Standardized configuration
Description Conf.
Voltage and frequency protection A
Table 10: Supported functions
Function
IEC 61850 A
Protection
Residual overvoltage protection ROVPTOV 3
Three-phase undervoltage protection PHPTUV 3
Three-phase overvoltage protection PHPTOV 3
Positive-sequence undervoltage protection PSPTUV 2
Negative-sequence overvoltage protection NSPTOV 2
Frequency protection FRPFRQ 2
Master trip TRPPTRC 2
Control
Circuit-breaker control CBXCBR 1
Condition monitoring and supervision
Trip circuit supervision TCSSCBR 2
Logging
Disturbance recorder RDRE 1
Fault recorder FLTRFRC 1
Measurement
Three-phase voltage measurement VMMXU 2
Sequence voltage measurement VSMSQI 1
Residual voltage measurement RESVMMXU 1
Table continues on next page
1MRS758335 B Section 3
REU611 standardized configuration
REU611 25
Application Manual
To Next Page
Loading...
