3.4 Configuration A
3.4.1 Applications
Configuration A for voltage and frequency-based protection is mainly intended for
utility and industrial power systems and distribution systems including networks with
distributed power generation. The configuration handles fault conditions originating
from abnormal voltages in the power system.
The protection relay with a standardized configuration is delivered from the factory
with default settings and parameters. The end-user flexibility for incoming, outgoing
and internal signal designation within the protection relay enables this configuration
to be further adapted to different primary circuit layouts and the related functionality
needs by modifying the internal functionality using PCM600.
1MRS758335 B Section 3
REU611 standardized configuration
REU611 31
Application Manual
To Next Page
Loading...
