ABB REM 610 - Page 100

Table footnotes from previous page
d)
If the input is out of operation or the optional RTD module has not been installed or is faulty, dashes will
be shown on the LCD and “999” when parameters are read via the SPA bus.
Each protection element has its internal output signal. These signals can be read
with parameters O1...O21 and the recorded functions with parameters O61...O81.
The state of the output contacts can be read or changed with parameters O41...O46
and the recorded functions read with parameters O101...O105.
Table 5.1.15.-9 Output signals
Status of the
protection
elements
Channel State of element
(R)
Recorded
functions (R)
Value
Pickup of
element 49
0,1 O1 O61 0/1
Alarm of element
49
0,1 O2 O62 0/1
Trip of element
49
0,1 O3 O63 0/1
Pickup of
element (48/14
PICKUP)
2
x (48/
14 TDLY) or 48/
14
0,1 O4 O64 0/1
Trip of element
(48/14
PICKUP)
2
x (48/
14 TDLY) or 48/
14
0,1 O5 O65 0/1
Pickup of
element 50P-1
0,1 O6 O66 0/1 ;
Trip of element
51N
0,1 O7 O67 0/1
Pickup of
element 37
0,1 O8 O68 0/1
Trip of element
37
0,1 O9 O69 0/1
Pickup of
element 51N
0,1 O10 O70 0/1
Trip of element
51N
0,1 O11 O71 0/1
Pickup of
element 46
0,1 O12 O72 0/1
Trip of element
46
0,1 O13 O73 0/1
Trip of element
46R
0,1 O14 O74 0/1
External trip 0,1 O15 O75 0/1
Motor start up 0,1 O16 O76 0/1
Restart disable 0,1 O17 O77 0/1
Alarm of element
49/38-1
0,2 O18 O78 0/1
100
REM 610REM 610
Motor Protection Relay
Technical Reference Manual - ANSI Version
1MRS755537