ABB REM615 ANSI - 29. Functions, codes and symbols

ABB 41
Motor Protection
REM615 ANSI
Product Version 2.0
1MAC251744 -PG Rev. A
Issued: 03.01.2010
29. Functions, codes
and symbols
Table 72. REM615 Functions, codes and symbols
Function IEC 61850 ANSI C37.2-2008
Protection
 ree-phase non-directional time overcurrent
PHLPTOC
51P
 ree-phase non-directional instantaneous overcurrent, low-set,
instance 1
PHHPTOC1 50P
Ground non-directional time overcurrent EFLPTOC1 51G
Neutral, directional time overcurrent DEFLPDEF1 67/51N
Circuit breaker failure protection CCBRBRF 50BF/50NBF
Master trip, instance 1 TRPPTRC1 94/86-1
Master trip, instance 2 TRPPTRC2 94/86-2
Arc  ash detection (AFD), instance 1 ARCSARC1 AFD-1
Arc  ash detection (AFD), instance 2 ARCSARC2 AFD-2
Arc  ash detection (AFD), instance 3 ARCSARC3 AFD-3
Negative sequence overcurrent protection for motors, instance 1 MNSPTOC1 46M-1
Negative sequence overcurrent protection for motors, instance 2 MNSPTOC2 46M-2
Loss of load supervision LOFLPTUC 37
Motor load jam protection JAMPTOC 51LR
Motor start-up supervision STTPMSU 66/51LRS
Phase reversal protection PREVPTOC 46R
 ermal overload protection for motors MPTTR 49M
 ree-phase undervoltage protection PHPTUV 27
Positive sequence undervoltage protection PSPTUV 27PS
Negative sequence overvoltage protection NSPTOV 47
Control
Circuit-breaker control CBXCBR1 52
Condition Monitoring
Circuit-breaker condition monitoring SSCBR1 52CM
Trip circuit monitoring, instance 1 TCSSCBR1 TCM-1
Trip circuit monitoring, instance 2 TCSSCBR2 TCM-2
Current circuit supervision CCRDIF1 CCM
Fuse failure supervision SEQRFUF1 60
Machine run-time counter, instance 1 MDSOPT1 OPTM-1
Machine run-time counter, instance 2 MDSOPT2 OPTM-2