ABB RER670 - Page 8

Section 5 Configuring the IED and changing settings....................45
Overview...........................................................................................45
Configuring analog CT inputs........................................................... 46
Supervision of input/output modules................................................ 46
Section 6 Establishing connection and verifying the SPA/IEC
communication............................................................... 49
Entering settings...............................................................................49
Entering SPA settings..................................................................49
Entering IEC settings...................................................................49
Verifying the communication............................................................ 50
Verifying SPA communication..................................................... 50
Verifying IEC communication...................................................... 50
Fiber optic loop................................................................................. 51
Optical budget calculation for serial communication with
SPA/IEC .......................................................................................... 51
Section 7 Establishing connection and verifying the LON
communication............................................................... 53
Communication via the rear ports ....................................................53
LON communication.................................................................... 53
The LON Protocol........................................................................54
Hardware and software modules.................................................54
Optical budget calculation for serial communication with LON ........55
Section 8 Establishing connection and verifying the IEC 61850
communication............................................................... 57
Overview...........................................................................................57
Setting the station communication....................................................57
Verifying the communication............................................................ 58
Section 9 Testing IED operation.....................................................59
Preparing for test.............................................................................. 59
Requirements.............................................................................. 59
Preparing the IED to verify settings............................................. 61
Activating the test mode................................................................... 62
Preparing the connection to the test equipment............................... 62
Connecting the test equipment to the IED........................................63
Releasing the function to be tested.................................................. 64
Verifying analog primary and secondary measurement................... 65
Testing the protection functionality................................................... 66
Forcing of binary input/output signals for testing.............................. 67
Forcing concept........................................................................... 67
How to enable forcing..................................................................67
Table of contents
2 Railway application RER670 2.2 IEC
Commissioning manual