ABB RET620 - Page 12

LD0.SRGAPC1 Multipurpose binary outputs - flip-flop
resets (1)................................................................................59
LD0.SRGAPC2 Multipurpose binary outputs - flip-flop
resets (2)................................................................................60
Analog inputs....................................................................................60
System functions.........................................................................60
CTRL.LLN0 Local remote station off......................................60
LD0.LPHD1 System values....................................................61
LD0.LEDGGIO1 LHMI LED indications (3 states)..................61
LD0.DNPGGIO1 Active parameter setting group...................61
Switchgear functions...................................................................62
CTRL.CBCSWI1 CB 4-pole (2 bit) position value..................62
CTRL.CBCSWI2 CB 4-pole (2 bit) position value..................62
CTRL.DCSXSWI1 Disconnector 1, 4-pole (2 bit)
position values........................................................................62
CTRL.DCSXSWI2 Disconnector 2, 4-pole (2 bit)
position values........................................................................62
CTRL.DCSXSWI3 Disconnector 3, 4-pole (2 bit)
position values........................................................................62
CTRL.DCSXSWI4 Disconnector 4, 4-pole (2 bit)
position values........................................................................63
CTRL.DCXSWI1 Controllable disconnector 1, 4-pole (2
bit) position values..................................................................63
CTRL.DCXSWI2 Controllable disconnector 2, 4-pole (2
bit) position values..................................................................63
CTRL.DCXSWI3 Controllable disconnector 3, 4-pole (2
bit) position values..................................................................63
CTRL.DCXSWI4 Controllable disconnector 4, 4-pole (2
bit) position values..................................................................63
CTRL.ESSXSWI1 Earth switch 1, 4-pole (2 bit) position
values.....................................................................................64
CTRL.ESSXSWI2 Earth switch 2, 4-pole (2 bit) position
values.....................................................................................64
CTRL.ESXSWI1 Controllable earth switch 1, 4-pole (2
bit) position values..................................................................64
CTRL.ESXSWI2 Controllable earth switch 2, 4-pole (2
bit) position values..................................................................64
Sensors and monitoring functions...............................................65
LD0.SSCBR1 Circuit-breaker condition monitoring
values.....................................................................................65
LD0.SSCBR2 Circuit-breaker condition monitoring
values.....................................................................................65
LD0.TPOSSLTC1 Tap changer position value.......................66
Metering and measurand functions.............................................66
LD0.CMMXU1 Phase currents (1)..........................................66
Table of contents
6 RET620
Point List Manual