ABB RIO600 - Writing Parameters to the Device

GUID-35367032-5CB6-43E9-82C8-B97E68BC3F14 V1 EN
Figure 41: Viewing parameters display in PST after selecting LECM
3. Change the values of the IP Address, Subnet mask, Default gateway, IP
SNTP primary and IP SNTP secondary parameters based on the required
configuration.
4.4 Writing parameters to the device
1.
Click to write parameters to the device.
The Write parameters to RIO600 dialog box opens.
2. Under Parameter range, select which parameters are written to the device.
• All parameters of a device like RIO600
• A selected group of parameters like General Parameters
• A selected parameter like IP Address
Section 4 1MRS757489 A
Using the Parameter Setting tool
40 RIO600
Configuration Manual