ABB RIO600 - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction.......................................................................3
This manual........................................................................................3
Intended audience..............................................................................3
Product documentation.......................................................................3
Product documentation set............................................................3
Document revision history.............................................................3
Related documentation..................................................................4
Symbols and conventions...................................................................4
Symbols.........................................................................................4
Document conventions..................................................................4
Section 2 RIO600 overview..............................................................7
Overview.............................................................................................7
Module configuration.....................................................................8
Configuration and engineering tool for RIO600..................................9
PCM600 and RIO600 connectivity package version.....................9
Hardware and software requirements................................................9
RIO600 engineering flow..................................................................10
Section 3 Setting up a project........................................................11
Handling connectivity packages.......................................................11
Uninstalling connectivity packages .............................................11
Installing connectivity packages..................................................11
Activating connectivity packages ................................................14
Creating a new project......................................................................15
Building the plant structure...............................................................16
Inserting IEDs...................................................................................17
Inserting an IED in offline mode..................................................18
Inserting an IED in online mode..................................................24
Setting the technical key...................................................................32
Editing object properties...................................................................35
Section 4 Using the Parameter Setting tool...................................37
Viewing parameters..........................................................................37
Reading parameters from the device...............................................38
Setting communication and synchronization parameters ................39
Writing parameters to the device .....................................................40
Section 5 Using the Signal Matrix tool............................................43
Starting the Signal Matrix tool...........................................................43
Table of contents
RIO600 1
Configuration Manual