ABB T Series - Wire Connection

52
Zenith ZTGSE/ZTSSE 30-2500A ATS, USER MANUAL
AL/CU UL Listed Solderless Screw-Type Terminals for External Power Connections
Model
ATS
Rating
(A) Source/Load
Lug
Type Wire Range
Cables
per
pole
Cables
Tightening
Torque
1
,
lb-in (N-m)
ZTGSE(D)
ZTSSE(D)

    
    

    
    

 


 
 


 
   
    
    

    
     
    
Load    
ZTS
ZTSD
ZTSCT


     
     
     
1
Notice. Do not exceed this value - may cause damage to switch, voiding warranty
—
Table 16 Power Cable Torque Requirements
—
Avis
Les cosses sont préinstallées et serrées.
NOTE: Above table shows ATS lug details for source 1, source 2 and load.
The factory connects the breaker to the ATS on the NORMAL side. refer the respective
Sales Dimension drawing to get breaker lug range details
Notice
Lugs come pre-installed and torqued.
Wire Connection