ABB T566609 - Troubleshooting; Malfunctions When Starting

Operation Manual / TPL67-C.. - TPL71-C..
Troubleshooting
6
Malfunctions when starting
6.1
Page 67
© Copyright 2016 ABB. All rights r
eserved.
April 2016 HZTL2488_EN Revision C
Troubleshooting
Malfunctions when starting
6.1
Sluggish start-up
Possible causes
Elimination
Turbochar-
ger
Turbocharger contaminated Clean it
Damaged bearing Contact an ABB Turbocharging
Service Station
Rubbing rotor
Foreign object in turbocharger
Vibrations
Possible causes
Elimination
Turbochar-
ger
Rotor unbalance Contact an ABB Turbocharging
Service Station
Damaged turbine or compressor
Damaged bearing
Rubbing of rotating parts
Normal behaviour, no malfunction
Turbochar-
ger
Minor uniform wear around the periphery of rotor components,
caused by slight local rubbing of adjacent components, is permis-
sible. The compressor blades and turbine blades are then short-
ened somewhat. Certain tolerances must be observed to avoid a
significant loss of efficiency.
 If there is any doubt about the extent of rubbing, then an ABB
Turbocharging Service Station must be contacted.
 Have a dimension check carried out by an ABB Turbocharging
Service Station.
6
6.1