Operation Manual / TPL69-A10 / -A30 ... TPL77-A10 / -A30
8 Disassembly and assembly / 8.7 Fitting the cartridge group
© Copyright 2020 . All rights reserved. HZTL2481_EN Rev.D March 2020
8.7 Fitting the cartridge group
CAUTION
Oil orifices
There is an orifice for adjusting the oil pressure in each of the two oil
supply pipes of the bearing casing. When the cartridge group, the bear-
ing casing or the turbocharger-is being fitted to the engine, it must be
ensured that the orifices specified for the turbocharger are installed in
both oil supply pipes.
u Check that the oil orifices have been correctly installed.
u Remove cover from oil connection.
u Fit flange(42044) with screws(42064) and new gasket(42045).
u Attach one lifting gear each to the two ribs of the bearing casing
provided for this purpose.
u Remove supports (90450) and carefully insert cartridge group.
u Tighten screws (61059) and Verbus Ripp® washers (61058) evenly.
Page 99 / 134
To Next Page
Loading...
