To Next PageTo Next PageWhat to do if rotating parts in ABB TPS48-F32 Industrial Equipment are rubbing?
If you notice rubbing of rotating parts in your ABB Industrial Equipment, and there is any doubt about the extent of rubbing, then an ABB Turbocharging Service Station must be contacted.
What to do if ABB TPS48-F32 has a sluggish start-up?
If your ABB Industrial Equipment experiences a sluggish start-up, it could be due to a contaminated turbocharger, in which case you should clean it. Alternatively, a damaged bearing could be the cause, requiring you to contact an ABB Turbocharging Service Station.
General| Brand | ABB |
|---|---|
| Model | TPS48-F32 |
| Category | Industrial Equipment |
| Language | English |
Introduces safety aspects, residual risks, and operator responsibilities.
Outlines general safety for operation, work area, and specific tasks.
Details risks like mechanical hazards, noise, and hot surfaces.
Details requirements for lubrication, oil filtration, viscosity, and pressure.
Covers checks before and after commissioning and during operation.
Explains routine checks, visual inspections, and functional checks.
Details procedures for shutting down oil-cooled and water-cooled turbochargers.
Explains wet cleaning methods for the compressor stage.
Covers methods for cleaning turbine components to maintain efficiency.
Lists possible causes and solutions for sluggish start-up and vibrations.
Addresses causes of surging and potential component damage.
Covers issues like low oil pressure, speed changes, and temperature problems.
Step-by-step guide for disconnecting and removing the turbocharger.
Instructions for mounting the turbocharger, including torque values.
Detailed procedures for component removal and reassembly.
