42/18-54 EN Electro-pneumatic positioner TZID 19
Mounting TZID in parallel with an actuator turning clockwise
• Undo the setscrews on the
shaft adapter.
• Shift the adapter by 90°, as
shown in Fig. 12.
• Re-fasten the setscrews.
• Couple the positioner’s
adapter with the rotary actu-
ator’s shaft.
• Turn TZID clockwise by
approx. 105° (see Fig. 13).
• Fasten TZID with screws.
Fig. 12 Adapter position (shifted by 90°)
Setscrew with
flat point
Setscrew with
cone point
Clockwise
rotation of
the actuator
Clockwise rotation
of the positioner
Fig. 13 Mounting TZID in parallel with an
actuator turning clockwise
To Next Page
Loading...
