ABB UMC100-FBP - Wiring Vi15 X Inputs and Outputs; Connecting the Vi15 X Voltage Module and a Dx1 Xx IO Module

- 20 -UMC100-FBP
Universal Motor Controller
UMC100-FBP
Technical Description
FieldBusPlug / Issue: 03.2012
Lo gic
/
µ C
24VDC
Warn
Ready
G N D
Error
DOC
DO0
RX / TX
1CA
2CA
1CB
2CB
L1
L2
L3
L1
L2
L3
*)
*) Functional earthing only VI150
Funktionserde nur VI150
#)
#) Only VI155
Nur VI155
VI15x
Connecting the VI15x Voltage Module and a DX1xx IO Module
To connect both a VI15x and a DX1xx module to the UMC use the UMCIO-CAB cable to connect the first
module with the UMC. And use the IOIO-CAB cable to connect the first module with the second module.
The module order does not matter.
 Wiring diagram of the VI15x-FBP modules
Wiring VI15x Inputs and Outputs
The diagram below shows the block diagram and wiring of both the VI150 and the VI155 modules.
The relay output is a normally open contact and can be freely used.
The inputs L1, L2, L3 must be connected to to corresponding supply phases.
The 0V of the VI150 supply must be connected to ground for proper measurement.