ABB UniGear ZS2 UniSafe 36 - Page 22

Installation and maintenance instructions UniGear type ZS2 UniSafe-36 1YTW571780-012 Rev:E 01-2005 en Page: 22 of 25
Fig:4.2.4
Handle for CB Springs manual charging
Fig:4.2.5 Handles for CB racking and
Esw operation
Fig:4.2.6 Front panel of HD4 at test
position of CB
Fig:4.2.7
CB and VT racking handle
Fig:4.2.8
Multi-pole auxiliary circuit plugged-in and
locked at service position of CB
Fig:4.2.9
Front panel of HD4 at test position of CB
**
*
Fig:4.2.10 CB position limit switches inside the LV compartment * service (connected) ** test(disconnected)