Installation and maintenance instructions UniGear type ZS2 UniSafe-36 1YTW571780-012 Rev:E 01-2005 en Page: 9 of 25
2.3 Unpacking and transport
The packing is intended for transport and not for storing purpose. Upon receipt the switchgear must be
unpacked and installed under clean, dry, dust-free, indoor conditions and anti-condensation heaters should
be connected. The cubicles which are without vacuum packing are normally fixed to the pallet. The
palette is suitable for lifting by transpalette or fork-lift from all four sides provided that the width and length
of transpalette is fitting. If the packing includes vacuum bags they might be used for storage indoors or
under shelter for a period of time adapted to the ambient conditions. Packing for storage purpose can be
supplied upon specific request.
!
CAUTION! The center of gravidity may vary according to apparatus installed in panels.
CAUTION! Assure that the panel is not damaged,tilted or dropped.
The lifting beam in fig:2.3.3 is not included in the delivery. Consider min 1.5 ton lifting capacity for each
1000mm cubicle.
Fig: 2.3.1
554685-801
Ordering number for the lifting
handles
Fig: 2.3.2
Fig: 2.3.3
For each switchgear transport unit instructive labels
or dwg. is fixed on the wooden crate. Example:
Fig:2.3.4
Study those advices also and check the transport
tools before you attempt lifting and transport.
Fig: 2.3.4
Fig:2.3.5
Fig:2.3.6
At the installation place it will be necessary to remove the wooden transpalette under the panel and adjust the
placement. If a crane is not available than the panel can be lifted by 2 transpalettes or suitable jacking tools
and the panel can slide on 7-8 pcs of roller-tubes.
Pay attention to the hollow part under the cubicle fore-part. (
Fig:2.3.6)
To Next Page
Loading...
