ASSEMBLY OF THE SWITCHGEAR AT SITE 27
—
5/13 Contact spring
installation
—
5/13
29.3 3
29.3 3
29.3 3
29.3 3 29.3 3
a) Check the contact spring 29.3 surface without any crease and
deformation before installation.
3 Busbar
29.3 Contact spring
b) Pull open the contact spring 29.3, insert it into the hole of busbar 3.
3 Busbar
29.3 Contact spring
c) Turn the contact spring 29.3 out from hole of busbar 3.
3 Busbar
29.3 Contact spring
d) Press the contact spring 29.3, turn it down and make sure that the
bottom plane is parallel to the busbar 3.
3 Busbar
29.3 Contact spring
To Next Page
Loading...
