ABB Zenith ZTS T Series - 1.2 Definitions

12
Zenith ZTS(D) 30-1200A ATS, QUICK START USER MANUAL
—
Settings (Optional)
Time delays Default Value Possible range
  
  
Center-off delay  
Generator stop  
Set points
Voltage and frequency drop-out  
Voltage and frequency pick-up  
In-phase Monitor On Off, On
Manual Retransfer Off Off, On
Commit Transfer Off Off, On
Application 

See manual
—
Table 3
Settings can be changed via the HMI as shown in Figure 5 and 6. See section 4 of the
ZTG(D) O&M for further detail. A password is required to change parameters; the default
password is 00001. Alternatively, settings can be changed with Ekip Connect 3 software
using Ekip Programming module.
—
Fig. 5