Pg 7 of 32
03
Preparing the Sensor
Peel lid from the sensor pack and unscrew cap from the sensor
applicator. Line up marks on the sensor applicator and pack.
Press down firmly on the sensor applicator until it comes to
a stop. Lift the sensor applicator out of the sensor pack. The
sensor applicator is now ready to apply the sensor.
04
Applying the Sensor
Place the sensor applicator over the application site, press firmly,
and hold for a few seconds. Gently pull the sensor applicator away
from your body. Make sure the sensor is secure by pressing the
sensor down and running your finger along the sensor adhesive.
Get support and information at FreeStyleLibre.usGet support and information at FreeStyleLibre.us
Quick Tip
Make sure to rotate the site to allow skin to fully heal.
Switching arms each time can help.
CAUTION: Sensor applicator
will now contain a needle.
Do not touch inside sensor
applicator or place back
inside sensor pack.
NOTE: Sensor pack and
sensor applicator codes
must match or glucose
readings may be inaccurate.
To Next Page
Loading...
