Abit IP35 Pro - Usb Storage Function

BIOS Setup
IP35 Pro 2-19
[High Speed]: All USB devices operate on high-speed mode.
[Full/Low Speed]: All USB devices operate on full/low-speed mode.
- USB Keyboard Support Via
Select [BIOS] for the legacy operating system (such as DOS) that does not support USB
keyboard.
- USB Mouse Support Via
Select [BIOS] for the legacy operating system (such as DOS) that does not support USB
mouse.
- USB Storage Function
This option enables or disables the USB storage function.
 Onboard PCI Device
Click <Enter> key to enter its submenu:
Phoenix – AwardBIOS CMOS Setup Utility
Onboard PCI Device
IEEE 1394 Controller Enabled Item Help
Network Controller1 Enabled
- Invoke Boot Agent Disabled
Network Controller2 Enabled
- Invoke Boot Agent Disabled
Storage Controller Enabled
- Controller Mode IDE

:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
IEEE 1394 Controller
This option enables or disables the IEEE 1394 controller.
Network Controller1 / Network Controller2
This option enables or disables the LAN1/LAN2 controller.
- Invoke Boot Agent
This item allows you to use the boot ROM (instead of a disk drive) to boot up the system and
access the local area network directly.
Storage Controller
This option enables or disables the JMB363 controller that controls both IDE1 and eSATA1
ports.
- Controller Mode
This item selects the mode for devices connected through eSATA1 ports.