Abit KN9S - Ide Function Setup

 IDE Function Setup:
Click <Enter> key to enter its submenu:
Phoenix – AwardBIOS CMOS Setup Utility
IDE Function Setup
On-Chip IDE 1 Controller Enabled Item Help
IDE DMA Transfer access Enabled
IDE HDD Block Mode Enabled
On-Chip SATA Controllers Enabled
↓↑ →← :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
On-Chip IDE 1 Controller
This item allows you to enable or disable the IDE1 controller.
IDE DMA Transfer access:
This item selects the DMA mode for devices connected through IDE channels.
IDE HDD Block Mode
This item enables or disables the IDE HDD Block Mode.
On-Chip SATA Controllers
This item enables or disables the on-chip SATA controller.
3-12 KN9 SLI, KN9 Ultra, KN9S