Abit KN9S - Raid Configuration

BIOS Setup
KN9 SLI, KN9 Ultra, KN9S 3-13
 RAID Configuration:
Click <Enter> key to enter its submenu:
Phoenix – AwardBIOS CMOS Setup Utility
RAID Configuration
RAID Function Disabled Item Help
x - Serial-ATA 1 RAID Disabled
x - Serial-ATA 2 RAID Disabled
x - Serial-ATA 3 RAID Disabled
x - Serial-ATA 4 RAID Disabled
x - Serial-ATA 5 RAID Disabled
x - Serial-ATA 6 RAID Disabled
x - RAID ROM Enabled
↓↑ →← :Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
RAID Function
This item allows you to enable or disable the RAID function for Serial-ATA 1~6 ports.
- Serial-ATA 1 RAID ~ Serial-ATA 6 RAID
This item allows you to enable or disable the RAID function for each of the Serial-ATA 1~6 port
individually.
- RAID ROM
This item allows you to use the boot ROM of OnChip SATA to boot up system.
 Back to Integrated Peripherals Setup Menu:
On-Chip USB
Select the type of USB controller. Three options are available: Disabled  V1.1+V2.0  V1.1.
The default setting is V1.1+V2.0. If you choose to disable this item, the “USB Keyboard
Support” and “USB Mouse Support” items will not be available to select in Integrated
Peripherals menu.
- USB Keyboard Support via
Select [BIOS] for the legacy operating system (such as DOS) that does not support USB
keyboard.