INF Installation Utility for Windows
®
98 SE A-1
User’s Manual
Appendix A INF Installation Utility for
Windows
®
98 SE
After you’ve installed Windows
®
98, you need to install the drivers for your IDE & USB
devices. We will tell you step by step in the following section how to do this.
Note A-1
You have to install the INF Installation Utility before you install the VGA and audio
drivers. After installing Windows the quality of your display will be poor because it will
be set to 640*480 and 16 color. For the best screen capture quality, install the VGA
drivers and set the desktop to 800*600 using True Color.
Note A-2
Details of the Windows
®
98 SE operating system will not be mentioned in this manual.
If you have any problems with Windows
®
98 SE installation, operations and settings,
please refer to your Windows
®
98 SE user's manual or other resources provided by
Microsoft
®
Corporation.
First, check System Properties ) Device Manager ) System Devices, you will see that
the Intel 82815 Processor to I/O Controller as well as the Intel 82802 Firmware Hub Device
are not listed.
To Next Page
Loading...
