3-4 Chapter 3
VL6
User defined external clock and multiplier factor:
➤
➤➤
➤ User Defined
$$$$
$$$$$$$$
$$$$
Warning
$$$$
$$$$$$$$
$$$$
The wrong settings of the multiplier and external clock in certain circumstances may
cause CPU damage. Setting the working frequency higher than the PCI chipset or
processor specs, may cause abnormal memory module functioning, system hangs, hard
disk drive data lose, abnormal functioning of the VGA card, or abnormal functioning
with other add-on cards. Using non-specification settings for your CPU is not the
intention of this explanation. These should be used for engineering testing, not for
normal applications.
If you use non-specification settings for normal operation, your system may not be
stable, and may effect system reliability. Also, we do not guarantee the stability and
compatibility for settings that are not within specification, and any damage of any
elements on the motherboard or peripherals, is not our responsibility.
✏
Ext. Clock (PCI):
➤
66MHz (1/2)
➤
100MHz (1/3)
➤
133MHz (1/4)
➤
150MHz(1/4)
➤
140MHz (1/4)
➤
105MHz (1/3)
➤
110MHz (1/3)
➤
115MHz (1/3)
➤
120MHz (1/3)
➤
112MHz (1/3)
➤
103MHz (1/3)
➤
83MHz (1/2)
➤
75MHz (1/2)
➤
124MHz (1/3)
Note
CPU bus speed above 66MHz/100MHz/133MHz supported but not guaranteed due to
the PCI, processor and chipset specs.
✏
Multiplier Factor:
You can choose the following multiplier factors:
➤
2
➤
2.5
➤
3
➤
3.5
➤
4
➤
4.5
➤
5
➤
5.5
➤
6
➤
6.5
➤
7
➤
7.5
➤
8
➤
8.5
➤
9
➤
9.5
➤
10
➤
10.5
➤
11
➤
11.5
➤
12
However, differences will exist because of the various brands and types available.
Note
According to Celeron
™
PPGA MMX processor types, some Celeron
™
PPGA MMX
processors will have the multiplier factor locked and the signal disabled. In this situation,
there is no way to choose a higher multiplier factor.
✏
Speed Error Hold:
The default setting is “Disabled”. If you change the setting to “Enabled” when the
CPU speed setting is wrong, the system will hold.
To Next Page
Loading...
