ABL eMH1 - Identifying Your Product Variant

INTRODUCTION
6
Identifying your product variant
The eMH1 series comprises several model variants, which are mechanically and/or
electrically adapted to different usage profiles. For identification, a product compliance
plate is located at the back of the lockable housing cover shield near the hinge. Please
open the cover shield before taking the device into operation and check the compli-
ance plate to ensure that the model variant you have installed is the one described in
this manual.
(Illustration is approximate)
For identification, the model code
(EVSE XXX) as well as the power sup-
ply ratings (voltage, frequency, cur-
rent) indicated below it are especially
relevant.
The following charging stations are described in this manual:
MODEL POWER SUPPLY MODEL VARIANT
EVSE 502
230 / 400 V
50 Hz 16 A
Integrated charging socket according to IEC 62196-2, Type 2
with locking mechanism for separately available charging cable
(Type 2 to Type 2 or Type 2 to Type 1); integrated RCCB Type A;
integrated DC fault current detector; charging output 11 kW
EVSE 512
230 V / 50 Hz / 32 A
Single phase EVSE 502 model variant without integrated DC
fault current detector; charging output 7.2 kW
EVSE 522
230 / 400 V
50 Hz 16 A
Integrated charging socket according to IEC 62196-2, Type 2
with locking mechanism for separately available charging cable
(Type 2 to Type 2 or Type 2 to Type 1); integrated RCCB Type B;
charging output 11 kW
EVSE 552
230 / 400 V
50 Hz 32 A
3 phase EVSE 512 model variant with onsite RCCB required;
approved by TESLA MOTORS GmbH, charging output 22 kW
EVSE 562
230 V / 50 Hz / 32 A
Construction identical to the EVSE 512 model variant but onsite
RCCB required
; charging output 7,2 kW
EVSE 572
230 V / 50 Hz / 32 A
Construction identical to the EVSE 512 model variant but with
integrated DC fault current detector; charging output 7.2 kW
WARNING!
The information and technical specifications contained in this manual re-
late exclusively to the model variants mentioned in these instructions
and must UNDER NO CIRCUMSTANCES be transferred to other eMH1
models.
099999
14-12-23
EVSE502
230/400V 50Hz 16A
IP44
IEC 61851-1
IEC 61439-7 ACSEV