SAFETY AND OPERATING NOTICES
3
Operating instructions / Maintenance
Please note the following instructions for the operation and maintenance of your
eMH1 charging station:
• The device must be connected to the protective earth conductor of your electricity
supply.
• Ensure that the rated voltage and rated current of the device comply with the pa-
rameters of your local electricity grid and that the rated output is not exceeded dur-
ing charging operations.
• At all times comply with local safety regulations for the country in which you operate
the device.
• To disconnect the device completely from the power grid, the power supply must
be cut at your domestic miniature circuit breaker (MCB).
• Follow all information and instructions of the manufacturer for installing and operat-
ing the device.
• Do not operate the device in confined spaces.
• Make sure that the front cover shield is always locked to prevent unauthorized open-
ing of the housing. Keep the key in a place that is known to all authorized users.
• You must NOT UNDER ANY CIRCUMSTANCES make any changes to the housing
or the internal wiring of the device: Any disregard of this instruction fundamentally
breaches the guarantee provisions and voids the warranty with immediate effect.
• No parts to be maintained by the user are located inside the device.
• Only have qualified, specialist personnel repair and/or install the device.
WARNING!
This charging station is intended for connection to and operation on 230
V 50 Hz or 230 / 400 V 50 Hz mains power only. Power supply cables
may be installed below or above the wall surface. The cable should enter
the device on the underside of the bottom part of the housing (see page
11).
• Only use a dry cloth to clean the device. Do not use aggressive cleaning agents,
waxes or solvents (such as cleaning fluid or paint thinner), because they can dull the
displays on the device.
• The charging station MUST NEVER be cleaned using a pressure cleaner or similar
implement.
• Regularly check the charging socket and the separately available charging cable of
your eMH1 charging station for wear and tear. Pay special attention to the proper fit
of the connectors of the charging cable in the charging sockets of both the eMH1
and the vehicle.
To Next Page
Loading...
Need help?
General
