Installation – Preparing and fixing the wallbox in place |
11
6 Insert two of the included panhead screws into
the two upper fixing points using the screwdriver
(Torx) or the electric drill and Torx bit.
y The distance between screw head and wall
must measure 4mm.
4 mm
Preparing and fixing the wallbox in place
Continue to prepare the wallbox:
7 Open the housing cover of the wallbox with the
housing cover key and put it aside.
8 Loosen the screw of the internal electronic com-
ponents cover using the screwdriver (Torx) and put
it aside.
y Keep the screw in a safe place.
9 Use the utility knife to cut an opening for the
power supply cable into the large rubber grommet
in the housing base.
y For wiring up group installations, you must also
make cuts into the two smaller grommets for
the data cables (see "Data cable connections"
on page 14).
To Next Page
Loading...
