29
PROGRAMMING HANDSET
OK
OK
ABLOY
OK
ABLOY
O
K
Control values
Change
Control point
Decrease
Power switch
Increase
Set value
Reset error
4-Digit
Display
Transmitter
1. Switch power ON
2. Enter master code and press
2. Find control point and adjust value
3. Press
Errors:
ERR 1: Wrong master code
ERR 2: Communication error
ERR 3: Value was not saved
Factory settings; press both buttons
for 2 seconds (until FCLr-text diappears)
(Settings are available until power has been switched OFF/ON)
Aim to the
LED's
9V Battery
(Lithium or Alkaline)
Master code is 0000.
Power is switched off automatically after 10 minutes (idle state).
Use power switch to save batteries!!
n. 0.5 m
To Next Page
Loading...
