Absolute ABS-1500 - Absolute Boiler Specifications

Absolute Boilers ABS 1500-2000-2500-3000-4000
17
3.3 Absolute Boiler Specications:
- Fully assembled cast aluminum oor standing sectional hot water boilers.
- Premix burner with stainless steel cylinder with perforated holes for precise air-fuel mixture and velocity with a
stainless tube with woven steel ber for stable ame and heat insulation.
- Fully condensing boiler.
- ASME approved design, CRN design Reg. for each Canadian Province.(where applicable)
- Precise air to fuel ratio through ring range with high turn down of 10 / 1 is possible.
- Boiler comes complete with a digital combination ame safe guard and a boiler control, with comprehensive
operating, service and fault diagnostic capabilities.
- Firing capabilities, fully modulating [4-20MA].
- Capable of BMS control, 4-20MA
- Local-remote switch [enable/disable].(optional)
- Available for conventional chimney, direct vent and sealed combustion venting systems.
- Fully factory pressure and re tested.
- Distinctive powder coated enamel steel,
- Removable casing, without the use of tools
- Rigid steel boiler frame with castors for easy of maneuvering into boiler’s nal position.
- Certied by CSA for USA and Canadian markets.
- High combustion and thermal eciencies.
- No minimum temperature requirements
- Max 160 psi(10.8 bar) – System water operating pressure
- ASME safety relief valve
- Pressure & Temperature gauge
- LWCO
- Lead lag-Cascade (optional)
- Communication gateway, BACnet and other protocols available (optional)
- CSD-1 compliant
- Outdoor reset sensor (Optional)
- Flue gas temperature sensor for non metallic vent system (Optional).