25
PROGRAMMING
AUTO MODE (HIGH HUMIDITY TRIGGER)
Pressing the up or down button sets the high humidity
trigger. The devices will activate if the probe’s reading
meets or exceeds this threshold.
Once triggered, the devices will gradually ramp up to
the level set in ON mode. If the probe’s reading falls
below this trigger point, the devices will gradually slow
down to a stop or at the level set in OFF mode.
You may set this trigger below the low humidity trigger to create a specific range in which the
devices are active.
This is typically used with devices like dehumidifiers to help lower the humidity when it gets too
humid. For example, if you set a high humidity trigger of 70%, then your device will activate when
the humidity rises to 70% or higher, and turn off when it falls below 70%. Products shown here
may still be in development.
ON
HIGH HUMIDITY
TRIGGER POINT
OFF
70
32 100
LESS HUMID MORE HUMID
Any of the four trigger points can activate while you are in AUTO Mode, even if you are viewing another trigger point.
Set a trigger point to OFF if not in use, by holding down the up and down button. If there is a level set in OFF Mode
other than zero the devices will run at that level when triggered to turn o.
To Next Page
Loading...
Need help?
General
