AC S.A. All rights reserved. Copying, publishing, distribution and any usage of the full or partial data included in the herewith document, particularly pictures, drawings, illustrations, trade marks etc. is
strictly prohibited under the law.
Page 50 of 54
Figure 2.2.6 “Inj. dose” window
Such a situation usually accompanies dynamic engine performance, such as acceleration. In the
event additional injections are observed, watch STFT correction and if the mixture is too weak or
too rich, use the slide control to adjust the correction value as to make sure STFT indication is
identical with the one applicable to petrol (usually around 0%).
Figure 2.2.7 “Advanced settings” window
Shifting the slide control to the right makes additional LPG injections richer, while shifting the
slide control to the left makes additional LPG injections weaker.
In the event setting the multiplier through the multiplier line (1D button in Maps tab) is
insufficient for the entire rpm range, use the 2D map (2D button in Maps tab).
Figure 2.2.8 2D map view
In order to modify the multiplier value in the calibration area, highlight the area and edit the
multiplier value by pressing Enter and entering the desired value.
Figure 2.2.9 Changing the multiplier value in the 2D map view
You can also use + and - or ↑ and ↓ keys, while holding CTRL, to change the multiplier value.
Apply a 10% incremental change by holding the Shift key.
To Next Page
Loading...
