Accu-Chek insulin pump - System Check Start-Up Process

System Check Start-Up Process
Your pump performs internal tests at start-up when you insert a battery and when
you change the cartridge. When you insert a battery the whole start-up process
is performed. When only the cartridge is changed, the start-up process begins
at the SELF-TEST screen.
1. Put the pump in STOP mode.
2. The ACCU-CHEK logo appears.
Note:
While you are using the pump, its safety system monitors it continuously.
If the safety system detects a change from the normal state, an alert
(warning instruction) or an error (error message) occurs.
▲
!
Do not interrupt the start-up process by pressing keys
or by handling the insulin pump. Interruption of the
start-up process may lead to malfunctions of your
insulin pump.
If your insulin pump does not beep and vibrate as
described, or if individual numbers, letters, symbols
or lines are shown incompletely or not at all,
contact
Pump Support at 1-800-688-4578.
Chapter 2: Getting Started ACCU-CHEK Spirit Insulin Pump28
WARNING