Acer Aspire 1600 - Conditioning a New Battery Pack

47 Aspire 1600
Type the Supervisor Password and press e to access the BIOS Utility.
2.
When the User Password is set and Power on boot is set enabled, the following prompt appears at boot-
up when pressing
m.
Type the User Password (a symbol appears for each character you type) and press
e to use the computer.
If you enter the password incorrectly, an
x
symbol appears. Try again and press e.
3.
When the Power on boot is set enabled, the following prompt appears at boot-up.
4.
When the Hard Disk Password is set, the following prompt appears at boot-up.
Type the Hard Disk Password (a symbol appears for each character you type) and press
e to use the
computer. If you enter the password incorrectly, an
x
symbol appears. Try again and press e.
You have three chances to enter a password. If you successfully entered the password, the system starts
Windows.
Removing a Password
If you fail to enter the password correctly after three tries, the system hangs.
To change a password, follow the same steps used to set a password.
1.
Use the cursor
w/y keys to highlight a Password parameter (Supervisor Password, User Password,
Password on boot ) and press
e. The following prompt appears:
2.
Type Current Password, leave the “ Enter New Password” blank and press
e. Leave “ Confirm New
Password” blank and press e, then the password is removed.
Enter Password
Enter Password
Enter Password
Enter Current Password [ ]
Enter New Password [ ]
Confirm New Password [ ]