Chapter 3 70
NOTE:
Please make sure the CPU is attached with PIN1 on this side.
Removing the Upper Case
1.
See “Removing the Battery Pack” on page 56
2.
See “Removing the Optical Drive Module” on page 57
3.
See “Removing the Hard Disk Drive Module” on page 58
4.
See “Removing the Middle Cover” on page 61
5.
See “Removing the Keyboard” on page 62
6.
See “Removing the LCD Module” on page 62
7.
See “Removing the Keyboard Bracket” on page 67
8.
See “Removing the DC Charger Plate” on page 67
9.
Use a plastic flat screwdriver to disconnect the touch pad cable from the main board.
10.
To remove the upper case, first remove the two screws from the front side, and then remove the fifteen
screws from the backside of the main unit.
To Next Page
Loading...
