Chapter 3 62
Removing the Keyboard
1.
See “Removing the Battery Pack” on page 56
2.
See “Removing the Middle Cover” on page 61
3.
To remove the keyboard, first remove the three screws as shown here.
4.
Lift the keyboard upward carefully and put it on the upper case.
5.
Use a plastic flat screwdriver to help disconnect the keyboard cable from the main board carefully, then
remove the keyboard from the main board.
Removing the LCD Module
1.
See “Removing the Battery Pack” on page 56
2.
See “Removing the Middle Cover” on page 61
3.
See “Removing the Keyboard” on page 62
4.
Remove the two screws from the base of the unit.
5.
Remove the screw and disconnect the LCD coaxial cable from the main board.
To Next Page
Loading...
