63 Aspire 1600
6.
Remove the inverter cable from the main board with a plastic flat screwdriver.
7.
Remove the four screws as shown and then detach the LCD module from the main unit carefully.
NOTE:
Please arrange the coaxial cable and the inverter cable well in the way as shown after you connect
them to the main board.
Removing the LCD Bezel
1.
See “Removing the Battery Pack” on page 56
2.
See “Removing the Middle Cover” on page 61
3.
See “Removing the Keyboard” on page 62
4.
See “Removing the LCD Module” on page 62
5.
Remove the four LCD cushions as shown and the middle lower mylar on the LCD bezel, and then remove
the five screws below from the LCD bezel.
To Next Page
Loading...
