Chapter 3 133
5. Replace the MIC cable under the mylar tab strips,
and replace the MIC as shown. Secure the cable
by pressing down on the strips.
6. Replace the antenna cable as shown. Ensure
that the cable is inserted under each tab strip.
7. Secure the cable by pressing down on the
securing strip.
8. Place the LCD Panel in the back cover.
9. Secure the LCD module with the two securing
screws.
10. Insert the Camera Module (adhesive side down),
and secure by pressing down to insure cohesion.
11. Replace the two securing screws. 12. Connect the Camera Module cable.
To Next Page
Loading...
