64 Chapter 3
2. See “Removing the Hinge Covers” on page 63.
3. Locate and remove the six securing screws on the bottom of the computer.
4. Turn the computer over and open the LCD module to expose the Switch Cover.
IMPORTANT:The LCD module does not fully extend. Damage will occur if you attempt to extend the LCD
module beyond the manufacturer’s design.
5. Pull the switch cover up from the left or right corner, separating the back edge first.
Step Size Quantity Screw Type
Switch Cover
(red callout)
M2.5*6 6
Switch Cover
(cyan callout)
M2.5*4 2
To Next Page
Loading...
