Chapter 3 67
4. Remove the Power Save Board from the Switch Cover.
Removing the Power Switch Board
1. See “Removing the LCD Module” on page 68.
2. Remove the three screws securing the Power Save Board to the Switch Cover as shown.
3. Remove the power board by sliding it out from the securing tab as shown.
Removing the Keyboard
1. See “Removing the Switch Cover” on page 63.
2. Pull up on the center rear of the keyboard until the Keyboard snaps free of the securing tabs on both sides of
the Keyboard.
Step Size Quantity Screw Type
Switch Cover
(red callout)
M2.5*4 3
To Next Page
Loading...
