Acer Aspire T130 - Standard Disassembly Procedure; Opening the System; Removing the Front Panel; Removing the Cables

50 Chapter 3
Standard Disassembly Procedure
This section tells you how to disassemble the system when you need to perform system service. Please also
refer to the disassembly video, if available.
CAUTION: Before you proceed, make sure you have turned off the system and all peripherals connected to it.
NOTE: The Aspire T130 mechanical housing is similar to AcerPower F1. Therefore, this chapter base on F1
to have samll rectify but the CPU and Heatsink are different between the two models.
Opening the System
1. Place the system unit on a flat, steady surface.
2. Turn the housing back, and remove the screws as shown here.
3. Slide the side door out. Then remove it.
Removing the Front Panel
1. Release the six latches behind the front bezel.
2. Remove the bezel by following the instruction below.
Removing the Cables
1. Disconnect the Aux-In cable.