9
Chapter 1. Basic Operation
1.1 Turn On the Phone Power
Long press (or ) key for a few seconds to turn on the phone power and
enter standby mode.
1.2 Turn Off the Phone Power
Long press (or ) key for a few seconds to turn off the phone power.
1.3 Make a Call
ΠLong press (or ) key for a few seconds to switch your phone on.
• Enter your PIN and press (or ) key.
Ž After the PIN is accepted, your phone will start searching the designated
network automatically.
• After connecting to the network successfully, LCD display will show which
network you connect to and go into standby mode.
• In this stand-by mode, dial the phone number including the area code you
desire. Then, press (or ) key to send out your call.
When the network service is not available, the following sign “No
Service” will pop up on the screen.
When connected to the network other than your designated one,
“Limit Service” will appear on the screen. You can only make
emergency call.
During a call, you can use the in call functions as described in
page 13.
1.4 End a Call
Press (or ) key to end or cancel a call.
To Next Page
Loading...
